Find The Needle hay lifts and vertical builds
Move goods upward in Find The Needle with Hay Lifts that pass through platforms, Compact 2 m lifts, catwalks, ladders and wall bays.
Lift behaviour and the vertical building set follow the launch changelog and patches V15.4 and V16.4 (November 2026). Lift prices are shown in game.
Why build upward?
Because the floor plan runs out before the pile does. A factory that grows sideways eventually collides with the shed wall, the dig zone or the pipe run; a factory that grows upward keeps the pile face clear and shortens the distance between stages.
The vertical kit arrived with Early Access, and it is unusually complete for a first pass: lifts, catwalks, ladders, ramps, pillars, steel beams, half and glass walls, wall bays, glass floors and glass roofs.
How do Hay Lifts work?
A lift moves goods between levels. Three properties matter:
- They snap to a wall’s belt port or to a belt end in the air, so a lift can receive from a belt that ends mid-air over a platform.
- Lifts and pipes go straight through a platform, which means no hole to cut and no alignment problem.
- The buttons carry arrows, and the launch build already let lifts and stairs move more smoothly.
Machine ports sit on the build grid and machines can stack, so a lift usually lands on a machine’s top port rather than on a belt.
What is the Compact 2 m lift?
A smaller lift that fits platforms either way round and can sit on a door or hang from it. It is the piece for a one-metre rise or a doorway in a wall bay, where a full lift is overkill.
What else supports a vertical build?
| Part | What it does | Note |
|---|---|---|
| Catwalks | Walkways above the floor | They branch off each other and turn at their ends |
| Ladders | Climbable access, with ramps, pillars and steel beams | The alternative to stairs everywhere |
| Wall bays | Belt holes with a port at the floor or one metre up, plus a roller door | The clean way to pass a belt through a wall |
| Glass floors and roofs | See-through structure | Keeps a lower line visible from above |
| Platforms | Snap to whole tiles and whole metres | A drag lays around platforms already there |
| Jump Pad / Hay Landing Pad | Throws you across the yard; the pad catches you | Faster than walking a big shed |
| Hay Stairs | Access between levels | Costs money only, all game |
What did the patches fix?
Vertical builds were the buggiest part of launch, and most of it was fixed in two builds:
- A tuft on the floor no longer blocks a lift’s drop (launch changelog).
- Hay Lifts no longer throw loads off at top belt speeds, and Hay Pulpers no longer spill wads on the floor (V15.4).
- Lifts and stairs move more smoothly (launch changelog).
- Grass no longer comes up through the warehouse floor on MOUNT HAYVEREST with a big shed (V15.4).
- Vertical building got cheaper and faster (V16.4): walls and roofs cost about half what they did, catwalks and ramps cost half, and lifts run faster.
If a lift is spitting cargo on an older build, that is the bug, not your belt speed. One more V16.4 fix applies to every walled build: when you Extend the Shed, lamps and wall outlets now move with the walls, and any cable that ends up too long is taken down for you rather than left dangling.
How should I lay out a two-storey line?
- Put the heavy machines on the ground. Presses and Smelters are easier to feed and to read from the floor.
- Send product up, not hay. A lift carrying loose hay is a lift doing a belt’s job (hay products).
- Use one lift per route. Two lifts sharing a shaft are two places to look when the upper floor starves.
- Keep the vertical run beside the service aisle, so a cable or pipe can climb with it (water and pipes, conveyors and power).
- Leave the roof open over the pile. The pile retreats, and a glass roof over a dig zone is a roof you will rebuild.
What about falling?
Falling hurts now, and the scoreboard keeps count: jump off something tall and it reads HAY 1, BUBBA 0. The Jump Pad and Hay Landing Pad exist partly for that reason — the pad is the safe way down, and catwalks without rails are not.
For the wider layout, see first factory layout; for the machines that end up on the upper floor, the machines index.
Related Articles
guides
Find The Needle blueprints and Dismantle Mode
Save a Find The Needle build on a Blueprint Designer pad, copy it anywhere, and use the Needle Hammer to take it down with the refund shown first.
guides
Find The Needle day, night and lighting
Nights are brighter since V14.1 and Options has a brightness slider, but lamps, flood lights and a Light Sensor still pay for themselves in Find The Needle.
guides
Find The Needle demo versus the full game
The free demo stops at V8 and has no metal, Depot, pipes or blueprints. A straight list of what the Early Access build adds, and what it does not.
Was this helpful?
Thanks for the feedback!